Mounting. A single case size is used for most ranges of Magnehelic gages. They can be flush or surface mounted with standard hardware supplied. With the optional A-610 Pipe Mounting Kit they may be conveniently installed on horizontal or vertical 1 1/4" - 2" pipe. Although calibrated for vertical position, many ranges above 1 inch may be used at any angle by simply re-zeroing.
However, for maximum accuracy, they must be calibrated in the same position in which they are used. These characteristics make Magnehelic gages ideal for both stationary and portable applications. A 4 9/16" hole is required for flush panel mounting. Complete mounting and connection fittings plus instructions are furnished with each instrument.
PHYSICAL DATA
- Ambient temperature range: 20° to 140° F.*
- Rated total pressure: -20" Hg. to 15 psig.+
- Overpressure: Relief plug opens at approximately 25 psig
- Connections: 1/8"' NPT female high and low pressure taps duplicated - one pair side and one pair back.
- Housing: Die cast aluminum. Case and aluminum parts Iridite-dipped to withstand 168 hour salt spray test. Exterior finish is baked dark gray hammerloid.
- Accuracy: Plus or minus 2% of full scale (3% on - 0 and 4% on - 00 ranges), throughout range at 70°F.
- Standard accessories: Two 1/8" NPT plugs for duplicate pressure taps, two 1/8" pipe thread to rubber tubing adapter and three flush mounting adapters with screws. (Mounting and snap ring retainer substituted for 3 adapters in MP & HP gage accessories.)
- Weight: 1 lb. 2 OZ.
- * Low temperature models available as special option.
- + For applications with high cycle rate within gage total pressure rating next higher rating is recommended. See Medium and High pressure options lower left.
More details will be written later.
0 comments:
Post a Comment